Sine 2012, We have been specialized in only Marble

How do I Build a Trailer Winch?

by:Afaithstone     2020-10-11
You need a way to get the boat or other heavy objects to the cradle of the trailer.The winch achieves this through mechanical aids and gear and pulley ratios.You can install one on the trailer to give you the power you need to pull a boat or heavy weight onto the trailer.It will take a day to finish the project.Description difficulty: medium difficulty position, you want to connect the winch along the trailer arm.Mark this point with scratches on the metal.Place the winch holder on this mark and then there you can drill the accessory screw holes into the tow arm.Drill the holes on the trailer arm with the power bit and metal bit.Use a 1/2-inch bit.Place the bracket on the hole and align so that the screw will be installed in both holes at the same time, then place the screw in both holes and add a nut up and down each screw.Tighten the cradle with a wrench and lock it in place.Remove the line shaft rod from the center of the line shaft, then put the line shaft into the cradle, align the side hole of the cradle with the line shaft rod hole.Pass the line shaft rod through the Cradle, the line shaft and other line shaft holes.Connect the wire shaft rod with the nuts at both ends and lock it on the cradle.Connect the gear bushing to the line shaft spindle according to the gear bushing ratio.Run the black/negative cable from the deep circulating battery stored in the front of the trailer to the black/negative connection on the DC motor.Run Red/positive cable from battery to DC motor.Connect the cable to the battery terminal in red and black.Unplug the ground wire from the negative pole of the battery and attach the other end to the metal of the trailer.Fix the DC motor on the gear bushing on the bracket.Screw the motor into the position so that it stretches out from the trailer arm running perpendicular to the arm.85 feet of 3/8 at the end of the thread-Inch steel cable of the inlet hole of the inlet shaft cable.Turn on the DC motor and the line shaft starts to turn.Direct the cable to the wire shaft so it doesn\'t pile up.Turn off the motor when there is 1 to 2 feet left.Attach the C-Clip to the end of the cable line with a steel curly fid.Place the curler on the fid and press it tight so it protects C-clip.Loop the C-Clamp the cable on the double drawing eight knots.Lock the steel lock on the ring of the knot.Eric Cedric, once an Alaska native, has lived in California for 20 years.He published it on \"outside\" and \"backpacker\" and wrote a book about small-Alaska town, north-southeast.Cedric has been a professional mountaineering guide and field expedition leader for 18 years.He has worked in Russia, Iceland, Greece, Turkey and Belize.Cedric is a private pilot at Syracuse University.
Custom message
暂无友情链接数据
Chat Online 编辑模式下无法使用
Chat Online inputting...
Dear there ,thank you for your kind message .We'd check and come back to you as soon as possible .Should you need any more assistance ,please add our wechat account for more timely response. Wechat:jane5125